![]() ![]() Launch Native Access to check for the latest TRAKTOR software update. Note: See this article if troubleshooting a third-party TRAKTOR controller. the MIDI indicator does not light up when moving a button, fader, or knob. Hope the tweaks of the Gain knob settings are a help at the very least.The TRAKTOR software does not recognize an NI TRAKTOR controller i.e. I decided to make this the secondary function, because it would be better to allow the Key settings to be made with one hand. This also took the same tweaks on the Rotary settings. Then I mapped Shift+Gain to control Gain, including push to Reset. The Gain encoders are better able to do so than the Filter. I believe this to be a better solution then using Shift+Filter, because for Key changes it is more important to jump by exact finite steps. This took some tweaking, including setting the Rotary Sensitivity to 50% and the Rotary Acceleration to 14%. I also took the time to remap the Gain knobs to control Key, including push to reset. This makes more sense to me than changing the function of the Deck C or Deck D controls and it will illuminate in the same fashion. Then I mapped Shift+Mode to toggle between chained and single FX. ![]() I chose to remap the Mode button in each FX section so that it toggles Flux mode. Do not use shift buttons with another button when using Learn, simply add the corresponding Modifier(s). Oh, and when you click learn and push or turn the button you wish to use, be sure to unclick learn, so that the button will start to function properly. Output functions do not need modifiers set and all Controls other than Modifiers should have Override Factory Map checked. Functions that need Shift will get Modifier Conditions set to 1 and functions that don’t need shift should have Modifier Conditions set to 0. Over the course of the last couple days, I’ve worked out some similar settings.įirst thing to do was Add In Modifier #1 as Left Shift and Modifier #2 as Right Shift, with Interaction Mode set to Hold, Override Factory Map unchecked, and Button Options set to 1. Here is some of what I found that may help those that may need it. You can always delete a function that isn’t working. ![]() This truly allows you to customize the controller easily and without much risk of messing things up (at least on the NI controllers). I didn’t really see the need previously, but I’ve been wishing for an easier way to enter Flux Mode and Adjust Key. This prompted me to start playing around with these settings. the shift key) I have not tried this yet – but it sounds as if it should work. NOTE: You just have to remember to uncheck the ‘over-ride factory Map’ for the modifier (ie. ( EDIT: For those that wish to continue using decks C & D – a reader tells me that using ‘Shift+Deck C’ & ‘Shift+Deck D’ will work perfectly too. And that’s how you map flux mode to your Controller! Now you can just repeat this for the 2nd Deck.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |